22
GB
INSTRUCTIONS FOR THE USER
WARNING!
Installation, fi rst ignition and maintenance
work must be performed by qualifi ed per-
sonnel only, in accordance with the in-
structions provided.
Incorrect installation may harm individu-
als, animals or property; the manufacturer
will not be held responsible for any dam-
age caused as a result. If the appliance is
installed inside the apartment, make sure
that all provisions relating to the air inlet
and room ventilation (in compliance with
current legislation) are respected.
IGNITION PROCEDURE
BCA
7
6
5
4
3
2
1
Turn knob B from (o ) to (pilot).
7
6
5
4
3
2
1
Press knob B fully in and hold it there; now
press the piezoelectric igniter C.
Check for a fl ame though hole A. Once
the fl ame is on, continue holding knob B
pressed in for a further 20 seconds or so.
If the pilot fl ame does not stay on, repeat
the above procedure.
SETTING THE WATER TEMPERATURE
Knob B can be used to set the hot water
temperature.
Turn the knob from the ignition position
to the index corresponding to the de-
sired temperature: from 1 (around 42°C) to
7 (around 70°C).
7
6
5
4
3
2
1
To reduce gas consumption and run the ap-
pliance more e ciently, it is best to leave
the knob at setting 4 (around 50°C).
This temperature also reduces the forma-
tion of limescale inside the water heater,
when the water supply is very hard (exces-
sive calcium content).
WARNING!
Water heated to more than 50°C
can cause serious burns. Always check
the temperature of the water before us-
ing it.
SWITCHING THE APPLIANCE OFF
To switch the appliance o , turn knob B
to
(o )
.
7
6
5
4
3
2
1
SUGGESTONS FOR USE
Make sure that all hot water taps are tight
and do not leak, as any leaks cause use
of gas and can increase the water tem-
perature.
To Next Page
Loading...
