39 / EN
USER INSTRUCTIONS
Advice for user
- Avoid positioning any objects and/or appliances that could be damaged by water leaks beneath the water
heater.
- Should you not use any water for an extended period of time, you should:
• disconnect the appliance from the electrical supply by switching the external switch to ‘’OFF”;
• turn o the plumbing circuit taps;
- Hot water at above 50°C flowing out of the taps at the point of use could cause serious scalds or even death
from burns. Children, the disabled and the elderly are more exposed to the risk of burns. It is strictly forbid
-
den for the user to perform any routine or extraordinary maintenance.
To clean the external parts use a damp cloth soaked in soap and water.
OPERATION AND ADJUSTMENT OF THE OPERATING TEMPERATURE
The water heater is switched on and o by means of the external bipolar switch.
Do NOT plug in or pull out the power cord to switch the appliance on or o.
The water heater is equipped with a LED indicator to instantly check the operating status and a knob to
adjust the underlying temperature.
During the heating phase the LED (Fig.8, Ref.1) is red and turns blue once the set temperature is reached.
If the water temperature drops, for example after a withdrawal, the heating function will be automatically
activated.
Adjusting the operating temperature
The temperature can be adjusted by turning the knob (Fig. 8, Ref. 2) clockwise or anti-clockwise to lower
or raise the hot water flow rate.
To Next Page
Loading...
Need help?
General
