EasyManuals Logo

Aritech 2X-AF2-FB-PRT-P Installation Manual

Aritech 2X-AF2-FB-PRT-P
174 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #84 background imageLoading...
Page #84 background image
Chapter 3: Configuration and commissioning
78 2X-A Series Installation Manual
SNTP server
Select SNTP server to configure the Simple Network Time Protocol (SNTP)
server settings. SNTP is a networking protocol for clock synchronization.
Note: Polling settings for the SNTP server must be enabled separately see
Auto date and timeon page 96.
To configure the SNTP server:
1. Select Panel setup from the Main menu, and then select Communications.
2. Select SNTP server.
3. Enter the IP address of the SNTP server.
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.

Table of Contents

Other manuals for Aritech 2X-AF2-FB-PRT-P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Aritech 2X-AF2-FB-PRT-P and is the answer not in the manual?

Aritech 2X-AF2-FB-PRT-P Specifications

General IconGeneral
BrandAritech
Model2X-AF2-FB-PRT-P
CategorySmoke Alarm
LanguageEnglish

Related product manuals