Final Assembly
Control the vertical line of the whole stair and, if necessary, correct it by moving the support N16 (g. 1).20.
Disassemble the rst tread (L19 or L20) and drill the oor with a D. 14 mm (21. 35/64") tip in relation to the
present holes on the support N16 (g. 1).
Insert the parts C39 and tighten completely (g. 1).22.
Reassemble the rst tread (L19 or L20) and x on the oor, in relation to the rst baluster (C12), 23.
the part F01, by drilling with a D. 8 mm (5/16") tip. Use the parts B11, B12, B83 and B02 (g. 1).
Insert the baluster (C12) and tighten the part B02 (g. 1).24.
To Next Page