Model!CC-5,!CC-12,!CC-25!and!CC-40
Condensate Cooler and Liquid Tempering Device
Installation and Maintenance Instructions
This bulletin should be used by experienced personnel as a guide to the installation of the Model CC-5, CC-12, CC-25
and CC-40 Condensate Cooler. Selection or installation of equipment should always be accompanied by competent
technical assistance. You are encouraged to contact Armstrong International, Inc. or its local representative for
additional information.
Bulletin No. AY-707
Typical Installation
Note: Cooler can also be used with heat exchangers or any application that requires the hot water or condensate
temperature to be tempered. When using this device to cool hot condensate, it is required to vent all flash steam prior
to piping into the body of the cooler. The body and vent of the cooler are not sized to be a flash tank.
Option 'A'
Vent
Flash Tank
Condensate
(Greater than 180°F)
Hot Condensate
Option 'B'
Condensate or
Hot Water
(180°F or Less)
Vent to Atmosphere
(with gooseneck to prevent
dirt from getting into the
body of the cooler)
Cold Water
Tempered
Condensate
Sanitary
Sewer
Floor Drain
1" Minimum Air Gap Required
(to eliminate back siphonage)
Sensing Bulb
Condensate Cooler
To Next Page
General