EasyManua.ls Logo

Arrow AK4 - STEP 3: Cable Routing; Threading Cable Through Structure

Arrow AK4
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
WU05
STEP 3 ETAPE 3 3. SCHRITT PASO 3
A. Take end of cable and insert under roof panel at rib, over the side wall angle, and roof beams as shown.
A. Prenez l'extrémité du câble et insérez sous le panneau de toit à la nervure, par-dessus la cornière
supérieure latérale et les poutres de toit, de la manière illustrée.
A. Kabelende unter die Dachplatte bei der Rippe über dem Seitenwandwinkel und den Dachbalken (wie
gezeigt) einlegen.
A. Tome el extremo del cable e insértelo por la costilla, por debajo del panel del techo, pasando sobre el
ángulo de la pared y las vigas del techo, como se ilustra.
THREAD WIRE OVER ROOF BEAMS AT THE
RIB OF ROOF PANELS
FAITES PASSER LE CABLE PAR-DESSUS
LES POUTRES DE TOIT A LA NERVURE
DES PANNEAUX DE TOIT
DRAHT ÜBER DACHBALKEN BEI DER
DACHPLATTENRIPPE EINFÄDELN
HAGA PASAR EL CABLE SOBRE LAS VIGAS
DEL TECHO, POR LA COSTILLA DE LOS
PANELES DEL TECHO
OUTSIDE EXTERIEUR
AUSSENSEITE AFUERA
INSIDE INTERIEUR
BINNENSEITE ADENTRO