6
TANK
The Tank is where the actual developing process happens. On the inside, the lm wound onto
the reel, comes into contact with the chemicals. The side hole holds a rounded gasket set
out to prevent leaks during agitation through the external handle: it is necessary to make sure
that the gasket stays clean and undamaged. On the back of the Tank are listed working liquid
quantities: 300ml to ll half the tank and proceed with continuous agitation; 490ml to ll the
Tank completely and proceed with intermittent agitation.
LID
The Lid was designed to let liquids in and out, yet being lightproof. Thanks to the side dentels,
once in place, the Lid stably latches onto the tank to keep the light from leaking in. To remove
the Lid, you need to pull it upwards perpendicularly to the tank: avoid oblique movements.
Before starting a new process, make sure that the lid is completely dry, so to avoid drops to
compromise the correct loading of the lm.
| Contents - LID & TANK |
To Next Page
Loading...