Say you are running two mixers at once – perhaps one for the
monitor system and one for the main PA (or one for a broadcast
feed and one for the PA). If a performer wants his/her mic split
into a powered monitor and the PA,you will need the ability to
split the signal from the source so that the signal can go both
ways. It is also important that the output of the source encounters
the right impedance. For example,if you simply used a “Y”
adapter, signal strength and quality would be lost. For this reason,
the SplitCOM professional splitter has a built-in transformer.
Since you may be splitting the balanced output of an instrument
amp or preamp,another consideration is “hum”caused by a
ground loop. The SplitCOM splitter box also features a ground
lift switch to reduce that problem.
Specifications:
• The SplitCOM provides professional low-Z-mic/balanced-line
splitting facilities for one source.
• Balanced female XLR input.
• Transformer-balanced, 600 ohm male XLR output.
• Male XLR Thru output
• Ground lift switch
• Input/Output impedance (balanced): 600 Ohms
• Power:Passive device
• Dimensions: 3.75 x 2.875 x 1.5 inches (90mm x 75mm x 40mm)
• Weight: 1lb (454g)
Usage:
a.) Using a low-Z mic cable or balanced line cord,connect the
output of the source (mic,balanced amp line out, balanced
preamp line out,etc.) to the Input connector on the SplitCOM.
b.) With two similar cables,connect the SplitCOM’s Output and
Thru output to the mic inputs on the mixers or other devices.
c.) If a hum occurs,set the SplitCOM’s Ground Lift switch to the
“Lift” position.
March 2003
SplitCOM
Mic Splitter/Combiner
Creative audio solutions in cool little boxes.
ARTcessories
™
DESIGNED & DISTRIBUTED BY:APPLIED RESEARCH AND TECHNOLOGY • 215 Tremont Street • Rochester, New York 14608 • USA
For Customer Service,please call: 585.436.2720 • Email: cserve@artproaudio.com • www.artproaudio.com • ART-ARTcs-03/03
90 DAY
WARRANTY
Need help?
General