Need help?Do you have a question about the Artos Engineering Company CS 338 and is the answer not in the manual?
General| Brand | Artos Engineering Company |
|---|---|
| Model | CS 338 |
| Category | Computer Hardware |
| Language | English |
Details the machine's dimensions, weight, noise level, cut length range, and piece quantity.
Lists optional accessories like blades, belts, pre-processing tools, and prefeeders.
Describes key operator controls like the power switch, emergency stop, and safety guard.
Instructions for installing the wire straightener using provided screws.
Guides on how to select and change the wire guide tubes for different wire sizes.
Guiding wire through the straightener and into feed belts.
Extending wire into the guide tube and tensioning it.
Adjusts the outfeed belts gap for proper wire feeding after stripping.
Final step of installing the safety guard and scrap collector.
Lists and describes button functions and shows control panel diagrams.
Details the meaning of each field (A-L) shown on the run screen display.
Step-by-step guide for programming settings like length, strip, and quantity.
Lists the available modes: PART, PROGRAM MODE, SPEED, CALIBRATION, INCH/METRIC.
Details the process of storing new parts and recalling existing ones.
Lists options: Language, Wire (Long/Short), Wire Marking, Wire Out Sensor.
How to select wire length modes and configure the wire marking feature.
Setting dwell time, marking type, and distances for marks.
How to enable or disable the wire run-out sensor.
Selecting center strip for long/short wires and choosing left/right end.
Setting the offset from the wire end and the strip length for center stripping.
Using the '+' and '-' keys to change feed speed in 10 steps.
Pressing SELECT to enter the calibration mode and choosing to continue.
Discusses how wire diameter, insulation, and drag affect calibration.
Steps for calibrating and storing a generic part for new wire types.
Using the calibration tool to set the correct blade opening.
Measuring and inputting wire length for machine calibration.
Measuring strip lengths and adjusting values for left and right ends.
Process for storing new part programs and recalling existing ones.
Choosing between Inch (1) and Metric (2) display modes.
Step-by-step guide for replacing the machine's blades.
Ensuring proper alignment and re-tightening of blade holding screws.
Steps to remove pulleys, replace the belt, and re-tighten.
Resolving problems like incomplete cuts or long center strands.
Diagnosing and resolving problems with wire slug removal.
Troubleshooting conductor damage and specific wire stripping challenges.
Resolving issues with strip slugs not pulling off and inaccurate wire length.
Instructions for selecting the correct operating voltage using the fuse cartridge.
Procedures for replacing the machine's fuses.
To Next Page