38
7 - Programmed Setpoint
7.4 START/STOP OF A PROGRAM DIRECT MODE WITH THROUGH THE PARAMETER MENU
The various commands, supported by the controller, are dif-
ferent for each of the following operating phases:
A] when in Local Setpoint mode
B] during the execution of a program
C]when the program is in hold
Commands supported by the controllers
The different phase are displayed in a chained way, just
for easing the understanding of the functionality.
Two different mode for starting and stopping a program are
provided:
direct mode with the ê key
through the parameter menu
A
The Ö green led is flashed at high rate when the controlled
variable is out of the allowed deviation band
The current time of a segment is hold up to the time the variable
re-enter in the band.
275.0
274.8
Menu
prog
stat
run
stat
Hold
stat
res
275.0
274.8
RUN
333.0
329.0
RUN
Program
running
Ö led
continuously on
Program start
Program Hold
Program start
Program hold
Program reset
Continue up to
the program end
Program hold
Ö led flashing
Operator
mode
(local Setpoint)
Program
menu
PARAMETER MENU
Press until
Type of
operating
setpoint
Local Programmed Programmed
Phase
Start of a
program
Supported
commands
Execution
of a program
Hold
of a program
Setting
of Local
setpoint
When the
program is
ended it comes
back to normal
mode
Program
start
Program
stop
in local mode
Program
hold
Program
stop
in local mode
Program
continuation
Program
stop
in local mode
BAC
M5 UK•ed4 10-12-2004 16:20 Pagina 38
To Next Page
Loading...
