5. Remove ground wire (green with yellow
stripes) from external ground connector screw
and remove from center terminal block.
6. Connect ground (green) wire of cord to external
ground conductor screw.
7. Connect neutral (white) wire of cord under
center screw of terminal block.
8. Connect the other wires to outer screws.
9. Tighten the strain relief screws.
10. Replace terminal box cover on back of dryer.
11. Plug dryer into wall receptacle.
12. Turn power on at breaker/fuse box.
Customer Care Center28
1-800-898-1879
www.askousa.com
Installation instructions
To Next Page
Loading...
