11
ADJUSTING THE FEET
Place the washing machine so that it is stable.
1. Level the washing machine in longitudinal and
traverse direction by rotating the adjustable feet
(using a No. 32 spanner).
The feet allow levelling by +/- 1 cm.
2. When the appropriate height of feet is set, use the
wrench No. 17 to fi rmly fasten the counter-nuts
towards the bottom of the appliance .
3. Tighten the jam nuts (counter nuts) to the end
position.
This will reduce washing machine noise, vibration,
movement etc. to minimum.
1
2
3
MOVING THE WASHING MACHINE AND
TRANSPORT AFTER INSTALLATION
If you are moving the washing machine without
packaging, open the washing machine door and pull
the appliance by holding the washing assembly, as
indicated in the fi gure.
For any further moving of the appliance, use the
transport rods (the washing machine drum has to be
blocked).
(See chapter TRANSPORT PROTECTION.)
To Next Page
Loading...
