5309424
Pressure Relief
Follow these instructions whenever you are instructed to relieve pressure,
stop spraying for more than 10 minutes, check or service the equipment,
or install or clean the spray nozzle.
1. Engage trigger safety latch.
2. Turn Zip Clean off and remove ignition cable from
spark plug.
3. Shut off water supply. Disconnect from water.
4. Remove trigger safety latch and trigger gun to
relieve pressure. Then engage the safety latch.
Note: If you suspect the spray tip or hose is clogged or that pressure has not been fully relieved after
following this procedure, disengage trigger safety latch and trigger gun again.
To Next Page
Loading...