13
This device complies with pa 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful inteerence, and (2) this device must accept any inteerence received, including
inteerence that may cause undesired operation.
Any Changes or modications not expressly approved by the pay responsible for compliance could void the
user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to pa 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inteerence
in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful inteerence to radio communications.
However, there is no guarantee that inteerence will not occur in a paicular installation. If this equipment does
cause harmful inteerence to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to t to correct the inteerence by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This device meets the government's requirements for exposure to radio waves. The guidelines are based on
standards that were developed by independent scientific organizations through periodic and thorough
evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety
of all persons regardless of age or health. FCC RF Exposure Information and Statement the SAR limit of USA
(FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: Bluetooth Communication System (FCC ID:
2BEH5-Z1) has also been tested against this SAR limit. This device was tested for typical body-worn operations
with the back of the device kept 0mm from the body. To maintain compliance with FCC RF exposure
requirements, use accessories that maintain a 0mm separation distance between the user's body and the back
of the Bluetooth Communication System. The use of belt clips, holsters and similar accessories should not
contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may
not comply with FCC RF exposure requirements, and should be avoided.
FCC
Caution.
To Next Page
Loading...