40
2.11 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.15 No. 30)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Black)
(39-pin IDE1, see p.15 No. 8)
Note: Please refer to the instruction of your IDE device vendor for the details.
connect the blue end
to the motherboard
the red-striped side to Pin1
connect the black end
to the IDE devices
80-conductor ATA 66/100/133 cable
Serial ATA2 Connectors These four Serial ATA2 (SATA2)
(SATA2_2_3: see p.15, No. 14)
connectors support SATA data
(SATA2_4_5: see p.15, No. 15)
cables for internal storage
devices. The current SATA2
interface allows up to 3.0 Gb/s
data transfer rate.
SATA2_4 SATA2_5
SATA2_2 SATA2_3
SATA3_A1 SATA3_A2
SATA3_0 SATA3_1
SATA3_A3 SATA3_A4
Serial ATA3 Connectors These six Serial ATA3 (SATA3)
(SATA3_0_1: see p.15, No. 13)
connectors support SATA data
(SATA3_A1_A2: see p.15, No. 12)
cables for internal storage
(SATA3_A3_A4: see p.15, No. 11)
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate. If the eSATA3
port on the rear I/O has been
connected, the internal
SATA3_A4 will not function.
To Next Page
Loading...
