25
2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA2 Connectors These four Serial ATA2
(SATA2_0: see p.13, No. 10)
(SATA2) connectors support
(SATA2_1: see p.13, No. 8)
SATA data cables for internal
(SATA2_2: see p.13, No. 12)
storage devices. The current
(SATA2_3: see p.13, No. 11)
SATA2 interface allows up to
3.0 Gb/s data transfer rate.
Serial ATA (SATA) Either end of the SATA data
Data Cable cable can be connected to the
(Optional)
SATA / SATA2 hard disk or the
SATA2 connector on this
motherboard.
USB 2.0 Headers Besides four default USB 2.0
(9-pin USB6_7)
ports on the I/O panel, there
(see p.13 No. 15)
are two USB 2.0 headers on
this motherboard. Each
USB 2.0 header can support
two USB 2.0 ports.
(9-pin USB8_9)
(see p.13 No. 16)
1
USB_PWR
P-8
GND
DUMMY
USB_PWR
P+8
GND
P-9
P+9
SATA2_1
SATA2_0
SATA2_3
SATA2_2
USB 3.0 Header Besides two default USB 3.0
(19-pin USB3_2_3)
ports on the I/O panel, there is
(see p.13, No. 24)
one USB 3.0 header on this
motherboard. This USB 3.0
header can support two USB 3.0
ports.
IntA_ P1_D+
DUMMY
IntA_ P1_D-
GND
IntA_ P1_SSTX+
GND
IntA_ P1_SSTX-
IntA_ P1_SSRX+
IntA_ P1_SSRX-
VbusVbus
Vbus
IntA_ P0_SSRX-
IntA_ P0_SSRX+
GND
IntA_ P0_SSTX-
IntA_ P0_SSTX+
GND
IntA_ P0_D-
IntA_ P0_D+
1
To Next Page
Loading...
