33
the red-striped side to Pin1
2.11 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.12 No. 33)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Serial ATAII Connectors These four Serial ATAII (SATAII)
(SATA2_2: see p.12, No. 15)
connectors support SATA data
(SATA2_3: see p.12, No. 16)
cables for internal storage
(SATA2_4: see p.12, No. 17)
devices. The current SATAII
(SATA2_5: see p.12, No. 18)
interface allows up to 3.0 Gb/s
data transfer rate.
Serial ATA3 Connectors These four Serial ATA3 (SATA3)
(SATA3_0: see p.12, No. 13)
connectors support SATA data
(SATA3_1: see p.12, No. 14)
cables for internal storage
(SATA3_M1: see p.12, No. 11)
devices. The current SATA3
(SATA3_M2: see p.12, No. 12)
interface allows up to 6.0 Gb/s
data transfer rate. If you install
the HDD on the eSATA port on
the rear I/O, the internal
SATA3_M2 will not function.
SATA2_4 SATA2_2
SATA2_5 SATA2_3
SATA3_0 SATA3_M1
SATA3_1 SATA3_M2
Serial ATA (SATA) Either end of the SATA data
Data Cable cable can be connected to the
(Optional)
SATA / SATAII / SATA3 hard
disk or the SATAII / SATA3
connector on this motherboard.
connect to the SATA
HDD power connector
connect to the
power supply
Serial ATA (SATA) Please connect the black end
Power Cable of SATA power cable to the
(Optional)
power connector on each drive.
Then connect the white end of
SATA power cable to the power
connector of the power supply.
To Next Page
Loading...
