English
25
X300TM-ITX
Step 4
Move the stando based on the
module type and length.
e stando is placed at the nut
location A by default. Skip Step 4 and
5 and go straight to Step
6
if you are
going to use the default nut.
Otherwise, release the stando by
hand.
B
A
Step 5
Peel o the yellow protective lm on
the nut to be used. Hand tighten the
stando into the desired nut location
on the motherboard.
AB
AB
20
o
Step 6
Align and gently insert the M.2
(NGFF) SSD module into the M.2
slot. Please be aware that the M.2
(NGFF) SSD module only ts in one
orientation.
NUT1NUT2B
Step 7
Tighten the screw with a
screwdriver to secure the
module into place. Please do
not overtighten the screw as
this might damage the module.
B
A
To Next Page
Loading...
