5400LN Series Grade 1
Cylindrical Lever Lockset
Installation Instructions
3
80-9150-0056-010 04/24
Copyright © 2002, 2013, 2023, 2024, ASSA ABLOY ACCENTRA™ Access and Egress Hardware Group, Inc. All rights reserved. Reproduction
in whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
1-855-557-5078 Ext. 2 • www.accentra-assaabloy.com
5. Adjust lock for door thickness (if necessary).
(Lock is packed preadjusted for 1-3/4" (44mm) doors. Available for 2-1/4" (57mm) doors upon request.)
To Adjust for Thicker Door
1. Remove two (2) screws (A) from outside rose.
2. Slide outside rose (B) away from lock body .
3. Adjust rose plate (C) to desired door thickness per illustration at right.
4. Fasten outside rose to lock body with two (2) screws.
6. Install lock
Insert lockbody into door from outside making sure that lockbody frame
hooks latch case and retractor engages bolt tail(s).
DO NOT FORCE. (If lockbody does not engage latch easily,
check door preparation for errors.)
B A
Slide plate to
disengage
2" door
2-1/4" door
1-3/4" door
C
Latch
Retractor engages
bolt tail(s)
Lockbody
Frame engages
latchcase
To Next Page
Loading...
