5400LN Series Grade 1
Cylindrical Lever Lockset
Installation Instructions
5
80-9150-0056-010 04/24
Copyright © 2002, 2013, 2023, 2024, ASSA ABLOY ACCENTRA™ Access and Egress Hardware Group, Inc. All rights reserved. Reproduction
in whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
1-855-557-5078 Ext. 2 • www.accentra-assaabloy.com
Troubleshooting
1. Check door for proper installation (see pictures below). Verify 1/8" between the latch and strike.
2. Check hinges. They should not be loose or have excessive wear on knuckles.
3. If Latchbolt will not deadlock:
Either strike is out of line or gap between door and jamb is too great.
Realign strike or shim strike out towards flat area of latchbolt.
4. If Latchbolt does not retract or extend properly:
Latchbolt tail and retractor may not be properly positioned.
a. Remove lockset. Look through 2-1/8" hole and verify latchbolt tail is centered between top and bottom of hole.
b. Remove latchbolt and insert lockset. Look through latch hole and verify retractor mouth is centered in hole.
Adjust outside rose plate if not. (See #5 on page 3)
c. Rebore holes if necessary to line up retractor and tail.
Door must not bind
Door must not be warped
Door must not sag
Door must swing freely
To Next Page
Loading...
