Assa Abloy ACCENTRA 6000 Series - 3 Timer Mode; Installation

3. Timer Mode
A. Installation
In this configuration, the device is always energized with a 24 volt
input, and a timer circuit is opened or closed to control pushbar
retraction. A momentary or maintain switch is typically used to
perform this operation. For installations where the power input is
cycled to retract the device, refer to Section 2: Power Mode.
1. Rail retracts when timer input is closed. Mount 6000 Series
exit device using mechanical installation instruction sheet(s)
provided.
NOTE:
Ensure proper mechanical function before attempting electrical
retraction:
 Verify the pushbar can be fully depressed and the latch is fully
retracted.
 On vertical rod exit devices, verify that the latch bolts do not
enter hold-back position until the pushbar is fully depressed.
 Adjust device mechanically, as required, before applying power.
2. Ensure DIP Switch (position 3) disables Power Mode (Figure
15). Set to OFF to disable.
3. Connect the ElectroLynx harness in the door (Figure 16).
4. Plug the 8-pin and 4-pin ElectroLynx connectors from the
pushbar into the 3” ElectroLynx harness or splice into a non-
ElectroLynx harness.
5. Feed the 3” harness through the 1” hole in the door and secure
the pushbar to the door using the mounting bracket and two (2)
supplied screws.
NOTE:
Do not install the end cap until electrical operation is verified in order
to confirm LED signaling.
Do not discard the end cap and hardware.
Figure 15 - DIP Switch Setting for Timer Mode Installation
Figure 16 - Timer Mode Installation
6
6000 Series Rail with "B"
and MELR option using
8-pin and 4-pin Connector
NOTE: Earth Ground
required for Electrostatic
Discharge (ESD)
protection unless metal
door and frame are
already earth grounded;
otherwise, earth ground
wiring required at pin 4
Exit Device
Mounting Bracket
Screw Location
1" Diameter
Hole in Door
McKinney QC12 Electric
Hinge (with 8- and 4-pin
connectors)
ElectroLynx Door Harness
(with 8- and 4-pin connector)
1-855-577-5078 Ext. 2 • www.accentra-assaabloy.com
6000 Series MELR
Exit Devices
Installation Instructions
14
80-8150-0077-000 04/24
Copyright © 2017, 2023, 2024, ASSA ABLOY ACCENTRA™ Access and Egress Hardware Group, Inc. All rights reserved. Reproduction
in whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.