3. Timer Mode
A. Installation
B. Wiring
6. Connect the ElectroLynx harness to the hinge.
7. Plug the door harness’s 8-pin and 4-pin connectors into the hinge’s
ElectroLynx connector.
8. Secure the electric hinge to door.
NOTE:
Make sure no wires are pinched or damaged in the process.
Refer to detailed wiring instructions under Timer Mode wiring.
9. Apply 24V according to MELR contact ratings: Confirm that the LED
is blinking and close the timer input circuit to retract the device.
When the system retracts electrically, confirm that it fully unlocks
and that all bolts clear the strikes. Troubleshoot the device if issues
are observed using the steps outlined at the end of this section.
10. Store excess wiring under end cap and assemble with provided
screws. Avoid pinching wires.
ElectroLynx Opening Installation
This is the simplest installation method, requiring the installer to plug
the ElectroLynx connectors from the exit device to the harness to the
hinge and then to the pigtail, which is connected to the access control
system. See Figure 17 on the next page.
Requirements:
MELR Exit Device
3” ElectroLynx connector harness (not supplied with MELR option)
McKinney QC ElectroLynx hinge (type of hinge depends on the
application)
ElectroLynx door
1 - Black (MELR 0VDC)
2 - Red (MELR +24VDC)
5 - Orange ( "S" NC/NO)*
7 - Brown ( "B" NO)
8 - Yellow ( "B" NC)
3 - White ("S")
6 - Blue ( "B" C)
4 - Green (EG)
1 - Violet ( "O" C)
2 - Grey ( "O" NC/NO)**
3 - Pink (MELR Timer A)
4 - Tan (MELR Timer B)
6000 Series MELR
Exit Devices
Installation Instructions
15
80-8150-0077-000 04/24
Copyright © 2017, 2023, 2024, ASSA ABLOY ACCENTRA™ Access and Egress Hardware Group, Inc. All rights reserved. Reproduction
in whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
1-855-577-5078 Ext. 2 • www.accentra-assaabloy.com
To Next Page
Loading...
