1. Overview
G. Wire Locations and Positions
MELR option devices are supplied with one (1) 4-pin and one (1) 8-pin Molex® connector (See Figure 4). Molex connectors allow simple
installation using the ASSA ABLOY ElectroLynx® system.
* “S” NO/NC (Normally Open/Normally Closed) is selectable on controller (refer to “S” DIP switch Instructions). Factory preset is NO. See
Section 3-C, Timer Mode, Configuration Instructions DIP Switch settings for more details.
** “O” NO/NC (Normally Open/Normally Closed) is selectable on controller. Factory preset is NO. See Section 4 Optional “O” Trim Monitory
Switch for details.
Figure 4 - Wire color and Position
1 - Black (MELR 0VDC)
2 - Red (MELR +24VDC)
5 - Orange ( "S" NC/NO)*
7 - Brown ( "B" NO)
8 - Yellow ( "B" NC)
3 - White ("S")
6 - Blue ( "B" C)
4 - Green (EG)
4-pin Molex
1 - Violet ( "O" C)
2 - Grey ( "O" NC/NO)**
3 - Pink (MELR Timer A)
4 - Tan (MELR Timer B)
1-855-577-5078 Ext. 2 • www.accentra-assaabloy.com
6000 Series MELR
Exit Devices
Installation Instructions
6
80-8150-0077-000 04/24
Copyright © 2017, 2023, 2024, ASSA ABLOY ACCENTRA™ Access and Egress Hardware Group, Inc. All rights reserved. Reproduction
in whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
To Next Page
Loading...
