1. Overview
H. DIP (Dual Inline Package) Switch Settings
DIP Switch assignments are as follows, starting from left in Figure 5:
A. Closed (Switch #1 set to ON ) when selecting LBM/NC (Normally Closed) contact.
Or
B. Closed (Switch #2 set to ON ) when selecting LBM/NO (Normally Open) contact.
NOTE:
¸ Only 1 or 2 should be closed at one time, not both.
¸ 3: Closed when bypassing external trigger, i.e. Power Mode.
¸ 4, 5, 6: Select software options, allows up to 8 Time/Delay settings (See Section 3 Timer Mode).
¸ Default Setting: LBM/NO and Power Mode set to ON.
Figure 5 - DIP Switch Settings (Factory Default
Shown)
6000 Series MELR
Exit Devices
Installation Instructions
7
80-8150-0077-000 04/24
Copyright © 2017, 2023, 2024, ASSA ABLOY ACCENTRA™ Access and Egress Hardware Group, Inc. All rights reserved. Reproduction
in whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
1-855-577-5078 Ext. 2 • www.accentra-assaabloy.com
To Next Page
Loading...
