Assa Abloy Norton 5900 Series - Double Door Synchronization; Jumper Cutting for Double Doors; Double Door Settings

Copyright © 2010, 2014 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
ASSA ABLOY
80-9359-0001-020 (01-14) Rev 3
11
Sync cable for double doors (synchronizing of 2 operators)
How to cut the jumper for double doors
*For “Double egress doors”, these functions must be set separately for Master and
Slave as the arm systems as well as the air pressure may be different.
Notes:
• Locks on the “Master” and “Slave” doors must be connected to the Control
Unit on the corresponding operator.
• The OPD is to be connected to the “Master” Control Unit except for “Double egress”,
where each OPD must be connected to corresponding Control Unit.
• Door leaf mounted sensors must always be connected to corresponding Control Unit.
Function Door Design Cutting Jumper
Opening
Closing
Astragal
Jamming
Master
Slave
Synchronous
Synchronous
Asynchronous
Double egress
P/N: 59000CAB
MASTER SLAVE
Note:
The markings on the sync cable
determine which of the operators is the
master and slave. Cable length - 10 feet.
Astragal
Synchronous
No No
No cutting No cutting
Asynchronous
Yes
No
Cut black
No cutting
Asynchronous
Yes Yes
No cutting
Cut red
— —
Cut black Cut red
Jamming No jamming
Settings for double doors
Function
Settings
Master
SlaveCommon
X
X
X
Close/continue to open when the door is obstructed
X
*)X(
X
*)X(
X
X
Individual
X
Opening time
Closing time
Hold-open time
PAG On/Off
Level of Power Assist
Extended closing force
OPD Input or Mat Logic Input
X
X
X
X
X
X
X
X
Fail Secure/Fail Safe Locking
Lock release (Enable/Disable)
Open Delay Time
Latch Speed (Fast/Slow)
Master
Slave