Assa Abloy Norton 6000 Series - Onboard Programming Method

80-9360-1043-020 Rev 1 05/21
Copyright © 2021, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
5
6000 Series Programming Instructions: Onboard Method
Select arm type.
1. Select GO from the Door Setup REQUIRED menu
by pushing joystick to the right. (Figure 4)
2. Depending on your application, select PUSH or
PULL by moving joystick LEFT or RIGHT. (Figure 5)
Figure 6
Figure 5
Door Mode
PULL
Figure 4
Door Setup
REQUIRED
GO
Setup Using LCD Screen
PULL:
6011 PULL 110°
Select operator model.
1. After setting arm type, push joystick UP to select
operator model.
2. Select specic operator model by pushing joystick
LEFT or RIGHT. (Figure 6)
Pull: (Figure 7)
6011 PULL 110 deg
6051 PULL 110 deg
PUSH: (Figure 8 or Figure 9)
6021 PUSH 110 deg
6031 PUSH 110 deg
6061 PUSH 85 deg
6061 PUSH 90 deg
6061 PUSH 95 deg
6061 PUSH 100 deg
6061 PUSH 105 deg
6061 PUSH 110 deg
6071 PUSH 85 deg
6071 PUSH 90 deg
6071 PUSH 95 deg
6071 PUSH 100 deg
6071 PUSH 105 deg
6071 PUSH 110 deg
3. Push joystick UP.
Follow these steps after operator has been
successfully installed and power has been turned on
(see Page 4, Initial Wiring):
PULL: 6011 or 6051
PUSH: 6021 or 6031
PUSH: 6061 or 6071
Figure 7
Figure 8
Figure 9