Assa Abloy Norton 7200 Series - Selective Hold Open Cam Adjustment; Attach Cover

Copyright © 2010, 2014 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
ASSA ABLOY
80-9372-0100-020 (02-14)
6
Attach Cover
312
Attach cover using screws provided.
Selective Hold Open Cam Adjustment
3
11
Setting Hold Open Angle
• Make all required electrical connections
and turn power switch to on for non-
detectored units (detectored units
cannot be turned off at the closer). (See
previous step)
• Open door to desired hold open angle.
• Loosen cam screw and rotate cam until
switch closes and door holds open.
• Rotate cam until it touches the switch.
• Tighten cam screw but do not over
torque as this will cause damage to
cam.
• Force door out of hold open by closing
the door, then test hold open by
opening to hold open angle again.
a
5/32” hex
wrench
b
c
5/32” hex
wrench
e
d
Right hand pull-side shown.
Switch shown in hold open position (closed).
Backplate
SHO switch in
open position.
Closer not in
hold open.
SHO switch in
closed position.
Closer in hold
open.
Un-used pin