Assa Abloy NORTON RIXSON 5200 Series - Connections

5200 Series Programming Instructions
10
80-9352-0022-020 Rev 2 06/23
Copyright © 2023, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Figure 26
Connections
Operator inputs and outputs can be customized from
Connections application page. (Figure 27)
NOTE: Input and Output numbers are labeled on the
control board. (Refer to Figure 29 for Input Connections
and Figure 30 for Output Connections)
To change the function, select the input or output and
scroll through the drop-down menu to select the desired
function. (Figure 28)
NOTE: For definitions, refer to Input and Output
Connections. (page 11)
Figure 28
Save/Restore
Use this tab to transfer settings from one operator
to another or restore an operator to a saved setup.
(Figure 26)
y Save Operator Settings to a File:
Click this button to save the operator’s current
settings to a file.
y Select Setting Files to Restore:
Click this button to choose a saved file to load to
the operator.
y Restore Operator Settings from File:
This option will be grayed out and unavailable
until a connection to the receiving operator has
been established (refer to “Operator Setup via
Wi-Fi” on page 6) and a file is selected to load.
Once available, click this button to load the file
selected for the receiving operator.
D. Adjust the Operator Settings. (cont.)
Figure 27