Assa Abloy SARGENT 1431 Series - Door and Frame Preparation; Closer Body Installation; Foot and Rod Assembly Installation; Main Arm Installation

A1) Select closer mounting position based on the maximum door opening, as listed below
Note: For ADA applications, select the 160ϒ position
1
5
4
MAIN
ARM
INDEX MARK
ON SPINDLE
RIGHT HAND DOOR
POSITION OF
MAIN ARM WHEN
ASSEMBLING
TO SPINDLE
C
B1) Prep door and frame
Note: 3/32" pilot holes are required when Self Tapping Screws are being used
Note: If machine screws are being used, use a drill #16 (.177) and a #12-24 tap
B2) Install closer body onto the door
B3) Install Foot & Rod Assembly onto the frames
C1) Install main arm on the closer with the index mark on the spindle aligning with the # 2 on the main arm (as shown)
A
B
2
3
**If Butt, Frame and Wall Conditions Permit
Door Will Open 180ϒ
MAXIMUM DOOR
OPENING
120ϒ 7 1/2" 13 1/4"
160ϒ** 4 1/4" 10"
DIM. A DIM. B
C OF HINGE PIVOT
L
#12 X 1 1/2 SCREWS OR
#12-24 X 5/8 FLAT HEAD
MACHINE SCREW*
TOP OF DOOR
DOOR CLOSER
DIM. “B”
DIM. “A”
11
1
⁄ 8 "
1"
2-1/2"
7
⁄ 8 "
1
1
⁄ 4 "
2
9
⁄ 16 "
*SEE PAGE 8 FOR MORTISE NUTS
RIGHT HAND DOOR ILLUSTRATED. SAME DIMENSIONS APPLY FOR LEFT HAND DOOR.
2
5
⁄
8
" MIN
TOP RAIL
FRAME
DOOR
FACE OF DOOR
RAILS TO 1
3
⁄ 4 " MAY BE
USED PROVIDED FRAME
DOES NOT PROJECT
BEYOND FACE OF DOOR
2
5
⁄ 16 "
STANDARD APPLICATION
D
Attach hold open foot to frame with adjusting nut facing down for left hand door or up for right hand door, as illustrated below
FRAME FRAME
NUT FACES DOWN
NUT FACES UP
LEFT HAND
DOOR SHOWN
RIGHT HAND
DOOR SHOWN
2
Copyright © 2010, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written permission
of Sargent Manufacturing Company is prohibited.
A7140F