Assa Abloy SARGENT 1431 Series - Main Arm Installation; Hold Open Foot Attachment

Copyright © 2010, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written permission
of Sargent Manufacturing Company is prohibited.
A7140F
7
INSTRUCTIONS FOR INSTALLING TOP JAMB
CLOSER MOUNTED ON FRAME
ABOVE STOP SIDE OF DOOR
D
D1) Install main arm on the closer with the index mark on spindle aligned with the number on the arm
Note: Left Hand Doors -align index mark with the # 3 on the main arm (as shown)
Note: Right Hand Doors -align index mark with the # 1 on the main arm (as shown)
F1) Opening the door slightly, slide rod into swivel
arm and then close the door
F2) With the door closed, position the main arm so
it is at 90º to the door surface
F3) Tighten the arm screw securely
F
Adjust closer as required. See page 8 for details.
G
INDEX MARK
ON SPINDLE
INDEX MARK
ON SPINDLE
1
5
4
2
3
MAIN
ARM
45°
1
5
4
2
3
45°
MAIN
ARM
LEFT HAND DOOR
POSITION
OF MAIN ARM
WHEN
ASSEMBLING
TO SPINDLE
E
FRAME FRAME
NUT FACES DOWN
NUT FACES UP
LEFT HAND
DOOR SHOWN
RIGHT HAND
DOOR SHOWN
Attach hold open foot to frame with adjusting nut facing down for left hand door or up for right hand door as illustrated below.
POSITION OF
MAIN ARM WHEN
ASSEMBLING
TO SPINDLE
ROD
HOLD
OPEN ARM
ARM
SCREW
LEFT HAND DOOR
RIGHT
ANGLE
RIGHT HAND
LEFT HAND