INSTALL COVER AS FOLLOWS:
FOR STANDARD AND PARALLEL ARM APPLICATION
• Screw short cover screw (#8-32 X 5/16) into top of case
approximately 2 turns
• Assemble plastic support and long cover screw (#8-32 X 1 1/4)
into bottom of case approximately 2 turns
•Hold support against case (approximately 2 turns)
between flange and screw head
•Position cover on closer and tighten screws
FOR TOP JAMB APPLICATION
• Assemble plastic support and long cover screw (#8-32 X11/4")
into top of case approximately 2 turns
• Screw short cover screw (#8-32 X 5/16") into bottom of case
approximately 2 turns
•Slide cover into gap between flange and screw head. Position cover
on closer and tighten screws
GAP
SHORT COVER SCREW
PLASTIC SUPPORT AND
LONG COVER SCREW
INSERT IS REMOVABLE.
PLACE IN UNUSED OPENING
SHORT COVER SCREW
PLASTIC SUPPORT AND
LONG COVER SCREW
INSERT IS REMOVABLE. PLACE IN UNUSED OPENING
RIGHTHAND
ILLUSTRATED
FINAL ADJUSTMENT AND REGULATING PROCEDURE
FRAME
UNREINFORCED
DOOR
COVER
DOOR
STOP
MORTISE
NUTHEAD
DRILL
3/8" DIA.
HOLE FOR
MORTISE
NUTBODY
DRILL 1/4" DIA.
HOLE FOR MOUNTINGSCREWS
1. For top jamb and corner bracket
applications: The door closer foot
will be attached to the door in a
manner similar to that shown for
mounting the closer body.
2. The appropriate mortise nuts
and screws will be suppled based
on door thickness.
Door construction must provide a
bridge type reinforcement to prevent
the door rail from collapsing when
through-bolts are tightened.
Adjustment hold open arm
Slight tightening or loosening of hold
open nut changes holding position of door.
Note: To protect wall, trim and closer, use a door stop
located 10° beyond hold open position but not beyond
the max. door opening shown on instructions.
HOLD
OPEN
NUT
USE 15/16"
WRENCH TO
ADJUST NUT
Minimum recommended door closing time is 6 Seconds for
doors opened to 90 degrees.
Use 1/8” hex (Allen) wrench to adjust valves as needed.
Closing and latching speeds:
Turn valves clockwise to slow down or counterclockwise to
speed up door movement.
Backcheck:
To regulate the intensity of back check action, turn valve clockwise
to increase or counterclockwise to decrease checking.
CAUTION: Set valve for slight cushioning effect; closer can be
damaged if the checking action is too abrupt. Never use
the backcheck as a door stop. Always use a door stop to stop
the door.
Delayed action feature (Optional feature on some models):
“Delayed action” provides slow door closing through the
delayed action range. Turn valve clockwise to slow down or
counterclockwise to speed up door movement.
All rights reserved. Reproduction in whole or in part without the express written permission
standards.
To Previous Page
Loading...
