Copyright © 2020, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
05/31/20
A8239B • 800-810-WIRE (9473) • www.sargentlock.com12
SE LP10 7000 Series Multi Point Lock
Fig. 1A
Fig. 2
Fig. 1B Metal Door Shown
1 Door Preparation
A. Verify Hand and Bevel of Door
B. Door Preparation
2 Rod and Inner Case Installation
1. Refer to instruction sheet A7860 for rod and inner
case installation on metal doors.
2. Refer to instruction sheet A7971 for rod and inner
case installation on wood doors.
• Check hand of door. The Multi-Point lock may be handed.
• Door should be fitted and hung.
• Verify box label for size of the Multi-Point lock, function
and hand.
Left Hand
Reverse
LHR
Outside
Inside
Right Hand
Reverse
RHR
Prepare door according to appropriate template. If necessary,
refer to www.intelligentopenings.com.
• Metal door (MD/AD): A7860
- Templates: 4582
• Wood door (WD): A7971
- Templates: 4624
7
Installation Instructions
Important: If manufacturer has not pre-drilled door,
refer to instructions A8147B to prepare ELR mounting holes
in door, using plastic template included with the device.
Screw hole orientation is not affected by handing.
!
To Next Page
Loading...
