1-800-810-WIRE • www.sargentlock.com • A8205B 12
Copyright © 2018, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
01/31/18
IN220 Exit Device
• Check hand of door.
The exit device is non-handed and
the trim is field reversible.
• Door should be fitted and hung.
1. If mullion is used, install prior to installing hardware.
2. Doors should be pre-prepped (recommended).
3. Use appropriate templates:
• IN220 template A8214 (wood and metal)
• Exit installation instructions A6770
Note: Instruction examples show wood door installation.
For metal doors, route cables inside door.
Left Hand
Reverse
LHR
Outside
Inside
Right Hand
Reverse
RHR
Fig. 1A
Installation Instructions for 8877/8878 Rim Exit
A. Verify Hand and Bevel of Door
1 Door Preparation
B. Verify Product Label
C. Door Preparation
7
Outside of Door Inside of Door
Through Bolt Holes
Cylinder Hole
Door
Position
Switch
Raceway for PoE
Lever Hole
ET Through Bolt Hole
ET Through Bolt Hole
Trim Lever Hole
ET Through Bolt Hole
Wire Run Channel
(Wood Door)
Raceway
for PoE
Cylinder Hole
Through Bolt Holes
Fig. 1B
To Next Page
Loading...
