01/31/18
13 1-800-810-WIRE • www.sargentlock.com • A8205B
Copyright © 2018, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
IN220 Exit Device
Wood doors have 3/8” raceway to controller cutout and metal doors
have 3/4” raceway to the controller cutout.
Refer to template A8214.
1. Insert connector end of DPS through the raceway on the latch edge of
the door (Fig. 2A).
Note: For metal doors, use DPS Collar.
2. Push DPS firmly into place by hand.
IMPORTANT: DO NOT TAP SWITCH WITH ANY TOOL.
Wood Frame Metal Frame
Dim 1
3/8”
3/4”
Horizontal
of Strike
Door Position
Switch Hole
Vertical
of Strike
Dim 2
(From template)
Dim 1
Fig. 2B
DPS
(Door Position
Switch)
Collar is used only
with metal doors
Door Frame
DPS
(Door Position
Switch)
2 Install Door Position Switch (DPS)
To Next Page
Loading...
