1-800-810-WIRE • www.sargentlock.com • A8205B 26
Copyright © 2018, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
01/31/18
IN220 Exit Device
3 Mount Mortise & Exit Device Chassis
Inside of Door
(2) 1/4 x 2-3/8”
Flathead Machine
Screws (secures ET)
Exit Chassis
Fig. 3A
1. Slide mortise lock into door and loosely secure with (2) flat head screws.
NOTE: Exit chassis harness consists of a 6-pin female connector and two
different-sized ground lugs (Fig. 3A)
2. Feed 6-pin connector and larger ground lug straight through to outside of
door (Fig. 3A, B) while feeding smaller ground lug into wire hole, up through
wire channel and out through inside of door (Fig. 3A).
DO NOT PINCH THE WIRE HARNESS.
3. Begin to secure the exit chassis with through bolts
to the ET trim using (2) 1/4 -20 x 2-3/8”
flat head machine screws.
Fig. 3B Detail
Latch Bolt
Chassis
Chassis Lift Lever
Lever
To Next Page
Loading...
