1-800-810-WIRE • www.sargentlock.com • A8205B 30
Copyright © 2018, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
01/31/18
IN220 Exit Device
8 Outside Reader and Mounting Plate Installation
1. Orient the reader so the LED lens is at the top.
2. Feed the cable/connector through the door (from outside to inside).
3. Install the reader to the outside of door by aligning the mounting posts with the door
preparation holes.
Hold the reader flush against door while ensuring proper alignment.
Fig. 8A
To Next Page
Loading...
