01/31/18
31 1-800-810-WIRE • www.sargentlock.com • A8205B
Copyright © 2018, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
IN220 Exit Device
Gasket*
Inside
Mounting Plate
Cat 5e cable from hinge
(with ground wire)
Through-bolts
Ground wire
(Lock Body)
4. Next feed the cables/connectors through the inside mounting assembly (and gasket if required*).
5. Insert and partially tighten (2) through-bolts prior to installation of connectors.
NOTE: Cable lengths exaggerated for illustrative purposes.
8
Outside Reader Installation (Continued)
*Gasket is required for outdoor installations.
If installing with gasket; separate gasket from mounting plate to feed cables/connectors
through holes as indicated (Fig. 8B).
Once cables/connectors are fed through, reattach gasket to mounting plate.
6. Secure both ground lugs with #6-32 machine screw (Fig.8C).
Fig. 8C
Fig. 8B
To Next Page
Loading...
