1-800-810-WIRE • www.sargentlock.com • A8205B 34
Copyright © 2018, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
01/31/18
IN220 Exit Device
12
Inside Cover Installation
1. Assemble cover by hooking top edge on inside mounting plate.
2. Carefully press bottom of cover toward door without pinching wires.
3. Secure the cover with the security allen wrench.
Inside
Cover
Inside of Door
Security
Allen Screw
1. Retrieve harness from end of rail.
Note: Harness has limited travel and can be damaged.
2. Attach harness to female connector on chassis.
3. Install rail and screws per exit device instructions.
Note: This view shows rim exit device version.
13
Installation of Rail Assembly
Fig. 13
To Next Page
Loading...
