Instructions for Installation of
Keypad Rim & Mortise Exit Devices
KP8877 / KP8878
KP8977 / KP8978
Programming Instructions
The KP Keypad Lock can support 99 users. Each user is assigned a User Number in addition to the
code used for entry.
Example:
USER TYPE USER NUMBER USER CODE
(2-6 DIGITS)
Master
Emergency
Supervisor
01
02
03
1 2 3 4
2 2 2 2 2
3 0 3 0 3 0
Standard 04-97 2 6 5
Special Factory
10 Sec. Time Preset
98
99
1 3 6 8
- The Master Code is always User “01”. The Master Code assigns the Emergency and Supervisory Codes. It is
also used for programming and will override the deadbolt*. Users are deleted through the Master Programming
Code only.
- The Emergency Code is always User “02”. The Emergency Code will override the deadbolt* in the mortise lock
and has an unlock time of 10 seconds.
- The Supervisory Code is always User “03”. The Supervisory Code allows temporary lockout of selected users,
changes duration of unlock time, requests infrared interrogation output, and may add additional User Codes.
- The first User Code will be User “04” or higher. User numbers do not have to be used or entered sequentially.
- User codes “98” and “99” have a factory-set unlock time of ten seconds. This allows a handicapped person
extra time which would not be required by other users.
To Begin Programming:
The KP Keypad Lock is preset at the factory with Master Code “1234”. Entering “1234*” will unlock the lock
allowing the lever handle to retract the latchbolt.
Initial Set-Up Procedures:
The following are typical procedures** to follow when setting up your KP Series Keypad:
• If a mistake is made during any of procedures, depress the “*” several times until the yellow LED goes out.
• If no keystroke is made in a 30-sec time frame the programming up to that point will default and you will
have to start over.
This Keypad Exit Device has 99 User Codes available for programming purposes.
9
Copyright © 2014. 2021, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
02/28/21
21 A7137D • 800-810-WIRE (9473) • www.sargentlock.com
To Next Page
Loading...
