Assa Abloy SW100 - Start-up and Initial Setup; 11.1 Adjusting the Door Stop

11 Start-up
The spring pre-tension is factory set to 210° and is normally not necessary to adjust. If adjustment
has to be carried out, see page 62.
11.1 Adjusting the door stop
a Close the door.
b Turn the potentiometer SPTE to 0° (if not already on 0°).
CU-ESD
0°
SPTE
c Switch on the mains (the operator will find its closed position).
0
0
d Open the door to required open position, plus approx. 5/8” (15 mm), by turning the poten-
tiometer SPTE on the CU-ESD, clockwise.
0°
SPTE
≈ 95°
e Lift the lock kick cam and the door stop arm up, mount the stop arm on the splines, as close as
possible to the stop block 1). Fine-adjust if necessary with the screw on the stop block 2).
1) 2)
49Issue 2021-02-241005088-en-22.0
11 Start-up