Assa Abloy SW100 - 11.3 Auto-learn Procedure

f Close the door by turning the potentiometer SPTE to 0° and let the door close.
Note! Impulses are not accepted if SPTE is more than 0°.
0°
SPTE
5
1
4
2
3
Micro switch1
Lock kick cam2
Stop block3
Fine-adjustment screw4
Door stop arm5
11.2 Micro switch
Control the lock kick by turning the lock kick cam (2) when power is off. This lock kick gives a lock
kick at power failure for the last 3-10 degrees of closing to make sure that the door will fully close
and latch.
2
1005088-en-22.0Issue 2021-02-2450
11 Start-up