4 Technical specifications
Ensure that the door operator with technical specification below is suitable for the installation.
ASSA ABLOY Entrance Systems ABManufacturer:
Lodjursgatan 10, SE-261 44 Landskrona, SwedenAddress:
ASSA ABLOY SW200Type:
100-240 V AC +10/-15%, 50/60 Hz, mains fuse max 10A (building installation)Mains supply:
Note! The mains supply shall be installed with protection and an all-pole
mains switch with isolating capability of Category III, at least 3 mm between
contacts, shall be installed according to local regulations. These articles are
not provided with the door.
Max. 300 WPower consumption:
24 V DC, max. 700 mAAuxiliary voltage:
2 x T 6,3 AH 250 VMains fuse F1, F2:
Push arm system; EN 4-7, max. 160/1600Door weight/width (kg/mm):
Pull arm system; EN 4-5, max. 100/1250
800-1600 mmDoor width:
For PUSH = 160 kgm
2
(80 kgm
2
for 180° opening)Max. Inertia J:
For PULL = 80 kgm
2
Inertia = Door weight x (Door width)
2
/ 3
Selectable: 12V DC, max. 1200 mA / 24 V DC, max. 600 mAElectro-mechanical locking
device:
PUSH: 80° - 110°, with reveal 0 - 305 mmDoor opening angle:
PULL: 80° - 110°, with reveal 0 - 130 mm
PAS: only 80°-95°, with reveal 0 - 130 mm
variable between 2 - 12 secondsOpening time (0° - 80°):
variable between 4 - 12 secondsClosing time (90° - 10°):
1,5-30 secondsHOLD open time:
-20 °C to +45 °CAmbient temperature:
Max. 95%Relative humidity:
9 kgDrive unit weight:
IP20Class of protection:
IP54Degree of protection, control
actuators:
Third party approvals from established certification organizations valid for
safety in use, see Declaration of Conformity.
Approvals:
11Issue 2021-02-241009728-en-9.0
4 Technical specifications
To Next Page
Loading...
