12.1.2 Arm system selection
Factory set arm configuration is PUSH 210 mm, if other is required:
Select arm configuration on the DIP-switches according to the table below.
ON=1 OFF=0
Spindle location (hinge to outgoing spindle)Type of arm system
AS 4
DIP 8
AS 3
DIP 7
AS 2
DIP 6
AS 1
DIP 5
0000PUSH, 210 mmPushing
0001PUSH, 95 mmPushing
1110PULL 95, 95 mm
Distance (Reveal + Door thickness + hinge) = 0-80 mm
Sliding push/Offset pivot
1101PULL 210, 210 mm
Distance (Reveal + Door thickness + hinge) = 75-130 mm
Sliding push
0100Reveal 0-100 mmSliding push 180 degrees
0101Reveal 100-200 mmSliding push 180 degrees
0110Reveal 200-305 mmSliding push 180 degrees*
1000PULL, 210 mm Reveal 0-65 mmPulling PULL
1001PULL, 210 mm Reveal 65-130 mmPulling PULL
0011PULL, 95 mm Reveal 0-65 mmPulling PULL (narrow doors)
1010PULL, 95 mm Reveal 0-65 mm, opening angle up to 180 degreesPulling PULL/PAS
1011PULL, 95 mm Reveal 65-130 mmPulling PULL/PAS
1111Folding door
1111Concealed (With panic
switch)
0111Concealed (Without panic
switch)
- Only low energy mode*
- Max. door inertia 45 kgm
2
- Decreased opening and closing speed
Note! The Panic Break Out Switch, shall be a normally closed contact, and is only needed at the
Concealed inswing application.
Note! After changing any system selection a new LEARN must be carried out.
Note! If an undefined combination of AS1-AS4 is selected, then PUSH 210 mm is used as default.
1009728-en-9.0Issue 2021-02-2452
12 Electrical connection
To Next Page
Loading...
