Assa Abloy SW200 - 16 Advanced Settings; Learn with Advanced Setting of Back- and Latch-Check; Revert to Default Values for Back- and Latch-Check (Level 1)

16 Advanced settings
16.1 Learn with advanced setting of “back- and latch-check”
See the prerequisites for performing a “learn” under the heading Auto-learn – automatically sets
back and latch check (recommended) on page 63.
a Push the button once or twice as for auto-setting.
b Stop the door at required back-check.
c The door reverts towards closed position.
d Remove the stop.
e Stop the door at required latch-check.
f The door reverts to learn the fully open position.
g Remove the stop.
h The door reverts to closed position.
16.2 Revert to default values for “back- and latch-check" (Level 1)
a Disconnect batteries if any.
b Disconnect the mains.
c Press the LEARN BUTTON (LRN) and keep it depressed.
d Connect the mains.
e Watch the ERROR LED.
3 s
f Release the LEARN BUTTON after 1 flash (LED is out).
g The BACK CHECK, LATCH CHECK and OPEN POSITION have now reverted to default values.
h Disconnect the mains.
i Next time the mains is connected, a new learn is needed to be run, and the operator will use
the default values.
1009728-en-9.0Issue 2021-02-2470
16 Advanced settings