Besam SW200i Issued: 10-4-2011 Page 7
5. Check the mat molding and threshold. It should be
complete and secured with all required screws.
6. If the door has motion detector activation and floor
mat safety, one of the following three requirements
must be met, (see Figure 3).
Five inches of visible safety mat must extend
through the door opening onto the approach side.
Provide a photoelectric (door hold open beam)
across the door opening on the approach side.
The adjustable time delay in the door operator
must be set to at least 4 seconds.
7. Do Not move very heavy objects over floor mats.
General Safety
1. Breakout Stop - In-swing doors on center pivots can
be supplied with a breakout stop that will allow the
door to open to 90 degrees in the opposite direction
of normal traffic. Call your supplier for details.
When the door is pushed into the breakout mode, the
power to the operator is removed, (except spring
closer force).
2. Decals – The door should have traffic decals properly
displayed as follows:
An arrow sign (see Figure 4) shall be visible from the
approach side of a swinging door, mounted on the
door at a height of 58
5 inches (14713 cm)
from the floor to the centerline of the sign. The
sign shall be minimum of 6 inches (15.2 cm), in
diameter, having a green circle surrounding a
black arrow on a white background.
An international DO NOT ENTER sign (see
Figure 5) shall be visible from the side that
would swing toward pedestrians attempting to
travel in the wrong direction. It should be
mounted on the door at a height of
585inches
(14713 cm), from the floor to the centerline of
the sign. The sign shall be minimum of 6 inches
(15.2 cm) in diameter, having a red circle with
the wording, Do Not Enter, in white letters.
To Next Page
Loading...
