V4.4 03/08/18 TD0036 Page 17 of 39
This Document is uncontrolled when printed unless over stamped “CONTROLLED DOCUMENT”
6.3 REMOVING THE CABLE ACCESS PANELS (EXT. CABINETS ONLY)
If your system does not have extension cabinets you can skip this section.
Before you secure your cabinets to the wall you will need to remove the panel on the left hand side of each cabinet
except for the one that will be on the very end on the left. This is to allow a cable to run between each system.
1. Using a 7mm socket or equivalent, remove the four nuts on the inside of the system.
2. The panel can then be removed from the cabinet.
To Next Page
Loading...
