V4.4 03/08/18 TD0036 Page 26 of 39
This Document is uncontrolled when printed unless over stamped “CONTROLLED DOCUMENT”
Follow the process below to install the surge protection module.
1. The cover on the surge protection module is secured with M4 Torx screws. Remove the screws using a T25 Torx
driver and remove the cover. There will be an earth lead connected to the cover that can also be disconnected.
NOTE: Ensure the module is not connected to the mains power outlet before removing the cover.
2. Fix the module to the wall in a suitable location using the 4 fixing points in the base.
To Next Page
Loading...
