V9.7 01/05/20 UD0011 Page 117 of 177
This Document is uncontrolled when printed unless over stamped “CONTROLLED DOCUMENT"
13. SAGEM MORPHOSMART READER
13.1 INTRODUCTION
This document has been produced to outline some essential information regarding the Sagem MorphoSmart Fingerprint
Reader. Prior knowledge of the Traka Touch System is assumed.
13.2 SYSTEM REQUIREMENTS
Below is a list of minimum hardware and software requirements required for the Sagem MorphoSmart Fingerprint Reader
to operate correctly on Traka Touch.
13.2.1 SAGEM READER MODELS
The following Sagem MorphoSmart Fingerprint Reader models are currently supported.
MSO CBM 4MB IDENTLITE – 3000 user capacity (up to 2 fingers each)
(Sagem Part no:252711976)
Other variants have not been tested
13.2.2 TRAKA TOUCH OPERATING SYSTEM
For the Sagem MorphoSmart Fingerprint Reader to work with Traka Touch, the Traka Touch unit must have Windows CE
build version 1.9 or later installed. Navigate to the Help section to check the Build Version.
NOTE: If a Traka Touch Base Board or Process Module has to be swapped for any reason, replacements
might not have version Windows CE 1.9 installed as default and so please specify version Windows CE 1.9
or later when raising an RMA request! If you connect a Sagem MorphoSmart Fingerprint Reader to a version
of Windows CE less than 1.9, when you plug the reader in, you get a Windows CE dialog pop up requesting
the Driver Name.
13.2.3 TRAKA TOUCH APPLICATION
For the Sagem MorphoSmart Fingerprint Reader to work with Traka Touch, the Traka Touch unit must have Traka Touch
Application version 01.02.4256.41 (07-Sep-12) or later installed.
To Next Page
Loading...
