V9.7 01/05/20 UD0011 Page 122 of 177
This Document is uncontrolled when printed unless over stamped “CONTROLLED DOCUMENT"
5. Follow the on screen instructions to take 3 captures of the users’ fingerprint. This process is the same as shown
in the previous section ‘Manual Enrolment by Admin’. The image to the right shows the screen for 2 finger
enrolment with “Enrol Finger 1 of 2” visible.
6. If the fingerprint captures are successful you will be presented with the following screen. The User can now
access the system by the method explained in the next section.
13.6 HOW TO ACCESS THE SYSTEM
When the login screen is displayed, simply place your enrolled finger on the reader. If recognised, the system will log
you in.
NOTE: When the main login screen is shown, the red light on the reader will NOT illuminate if no users have
been enrolled in the database.
NOTE: To save energy, the fingerprint reader is disabled when the Screen Saver comes on. To activate it
again, just touch the screen to close the Screen Saver.
To Next Page
Loading...
