V9.7 01/05/20 UD0011 Page 159 of 177
This Document is uncontrolled when printed unless over stamped “CONTROLLED DOCUMENT"
Version 3.1 of the iMX28 Control Board incorporates 2 LCD Data Cable connections. Along with the standard 7” connector
used on the previous Control Board, there is now a 5” connector for use with a 5” LCD display. This Control Board is
required when upgrading a 16bit System to Traka Touch.
Each connector type can be identified by a number located on the board to the right of the connector. 7, for a 7”
display and 5, for a 5” display.
To Next Page
Loading...
